| Author |
Message |
|
|
Post subject: UART0 control in Total5200
 Posted: May 10, 2006 - 06:04 PM
|
|
New Member
Joined: May 10, 2006
Posts: 1
|
|
I have a Total5200. I used to control it through UART0 (control port) using HyperTerminal which suddenly ceased to work.
Instead of it showing startup sequence and such things it just doesn't show anything. Unfortiantly I don't have the network configuration linked to, so I can't do it from the ethernet too.
I tried to swith to the dBug mode but it doesn't send anything to the hyperterminal too. I tried using phindows but no luck with that either.
Any ideas guys?
Can I use the console (running on UART3) to control my system? Is there like a jumper or some hardware move that can get my control port running again? |
|
|
| |
|
|
|
 |
|
|
Powered by PNphpBB2 © 2003-2007 The PNphpBB Group
Credits |
|
|
FAQ
Search
Register
Log in to check your private messages
Log in
