| Author |
Message |
|
|
Post subject: new in QNX 6.0
 Posted: Nov 04, 2007 - 08:04 PM
|
|
New Member
Joined: Sep 26, 2007
Posts: 4
|
|
i just install a QNX 6.0 ISO on my PC but there are some hardware devices not working as (network card (pci DLINK) - sound card - HP printer )
how can start them ?
thank you.. |
|
|
| |
|
|
|
 |
|
|
|
Post subject: RE: new in QNX 6.0
Posted: Nov 04, 2007 - 10:20 PM
|
|
QNX Master
Joined: Sep 01, 2002
Posts: 2675
|
|
| If there where not detected then most likely there are not supported. 6.0 is VERY old.... |
|
|
| |
|
|
|
|
|
|
|
Post subject: RE: new in QNX 6.0
Posted: Nov 09, 2007 - 01:23 PM
|
|
Active Member
Joined: Nov 09, 2007
Posts: 12
|
|
Sure, try 6.2.1.
I didn´t have problems with the Devices on my first install. |
|
|
| |
|
|
|
|
|
|
|
Post subject: RE: new in QNX 6.0
Posted: Nov 11, 2007 - 08:52 PM
|
|
New Member
Joined: Sep 26, 2007
Posts: 4
|
|
yes , thank you for your reply
but are there a drivers for these hardware i can install? can i search for it? or not |
|
|
| |
|
|
|
|
|
|
|
Post subject: RE: new in QNX 6.0
Posted: Nov 12, 2007 - 12:11 AM
|
|
Senior Member
Joined: Jul 22, 2004
Posts: 317
|
|
I also would recommend trying 6.2.1 (or newer ;>). Since there are a lot of DLINK-Pci-based NICs i cannot guarantee, but i think a lot of them should work fine. As long as the HP-Printer is Postscript compatible there is an pretty easy setup (I hope i did not mix this now, long time no printer on QNX ^^). For sound i did not have yet a genuine sound card installed since we run own devices over a custom bus. Best is to check the supported hardware in the 6.2.1 docu to make sure  |
|
|
| |
|
|
|
|
|
|
Powered by PNphpBB2 © 2003-2007 The PNphpBB Group
Credits |
|
|
FAQ
Search
Register
Log in to check your private messages
Log in
