Skip navigation.
The QNX Community Portal

View topic - i2c device programming

i2c device programming

anything that doesn't fit to other groups.

i2c device programming

Postby Ericxx » Fri Dec 17, 2010 12:03 pm

Hello all,

I am developing a i2c device on the gumstix under 6.5.0. and the driver is supported already in the 650 release. Have been searching around but would appreciate your help in my problem. The i2c provides the set_slave_addr() function to specify the target slave address. But i have no ideas how to get the slave address. Thank you.

Senior Member
Posts: 158
Joined: Mon Jun 09, 2008 1:38 pm

Return to General Programming

Who is online

Users browsing this forum: No registered users and 2 guests