Skip navigation.
Home
The QNX Community Portal

View topic - Create partition FAT in NAND

Create partition FAT in NAND

anything that doesn't fit to other groups.

Re: Create partition FAT in NAND

Postby cleitonbueno » Tue Jun 07, 2016 12:52 pm

Right. But you must have the devil-may driver for this, right? I tried to devf-generic but without success.
I can "mount" ETFS without this devf-? My case is a NAND Micron.
cleitonbueno
Active Member
 
Posts: 34
Joined: Thu Mar 10, 2016 1:21 pm

Re: Create partition FAT in NAND

Postby nico04 » Tue Jun 07, 2016 1:12 pm

Usually, the devf driver sources needed for your board are in the BSP in src/hardware/flash.
nico04
Active Member
 
Posts: 79
Joined: Wed Sep 29, 2010 9:59 am
Location: France

Re: Create partition FAT in NAND

Postby cleitonbueno » Tue Jun 07, 2016 4:12 pm

Yes. But I'm using BSP I downloaded the QNX website does not. I will try to see some other than use this Micron memory.
cleitonbueno
Active Member
 
Posts: 34
Joined: Thu Mar 10, 2016 1:21 pm

Re: Create partition FAT in NAND

Postby cleitonbueno » Tue Jun 14, 2016 10:25 pm

Some example for dvd- driver for Micron Flash?
The BeagleBoard-xm uses Flash Micron, but devf- generates the error 'Bus Error' I have no knowledge with drivers for QNX.
cleitonbueno
Active Member
 
Posts: 34
Joined: Thu Mar 10, 2016 1:21 pm

Re: Create partition FAT in NAND

Postby nico04 » Wed Jun 15, 2016 6:58 am

nico04
Active Member
 
Posts: 79
Joined: Wed Sep 29, 2010 9:59 am
Location: France

Re: Create partition FAT in NAND

Postby cleitonbueno » Wed Jun 15, 2016 8:06 pm

Thanks, I will download, check the flash and etfs in BSP, I go compile and test. Soon answer.
cleitonbueno
Active Member
 
Posts: 34
Joined: Thu Mar 10, 2016 1:21 pm

Previous

Return to General Programming

Who is online

Users browsing this forum: No registered users and 1 guest