Skip navigation.
Home
The QNX Community Portal

View topic - difference between aps and ap command in QNX

difference between aps and ap command in QNX

For discussion of realtime and/or embedded programming.

difference between aps and ap command in QNX

Postby ninja123 » Tue Jan 05, 2010 10:21 am

Hi all,

Is there any difference between aps and ap commands?

My QNX Neutrino641 target throws an 'APS Scheduler not running' error when I use aps show. But with ap command although I create partitions none of them are displayed with ap show..

Please guide me
ninja123
Active Member
 
Posts: 36
Joined: Wed Dec 02, 2009 10:13 am

RE: difference between aps and ap command in QNX

Postby princi » Mon Feb 01, 2010 6:32 am

hi,
i too had the same isuue. Have u edited the build file as mentioned in the qnx adaptive partioning user guide ?

[module=aps] PATH=/proc/boot:/bin:/usr/bin:/opt/bin \
LD_LIBRARY_PATH=/proc/boot:/lib:/usr/lib:/lib/dll:/opt/lib \
procnto-instr
Is new boot image resolved the issue? Please reply.

Regards,
Princi
princi
Active Member
 
Posts: 12
Joined: Mon Feb 01, 2010 5:50 am

RE: difference between aps and ap command in QNX

Postby ninja123 » Mon Feb 08, 2010 1:57 pm

I was told that Adap part works from Neutrino 641 onwards. The aps command replaces ap command.

I had earlier had the older version and now with the 641 with procnto-instr in my build file, I have aps working :)
ninja123
Active Member
 
Posts: 36
Joined: Wed Dec 02, 2009 10:13 am

Postby princi » Mon Feb 08, 2010 2:13 pm

Thank you for the information. :)
I too have aps working :)
princi
Active Member
 
Posts: 12
Joined: Mon Feb 01, 2010 5:50 am


Return to Realtime and Embedded

Who is online

Users browsing this forum: No registered users and 4 guests