Skip navigation.
Home
The QNX Community Portal

View topic - how to USB under qnx 6.4.1

how to USB under qnx 6.4.1

For discussion of realtime and/or embedded programming.

how to USB under qnx 6.4.1

Postby bzxaggio » Wed Nov 10, 2010 7:56 pm

How to call USB command under QNX? Currently I would like to connect a GPS with the COBRA board through usb, but need to program, so any suggestions? How to write command under QNX/Linux? Thank you.
bzxaggio
Active Member
 
Posts: 16
Joined: Tue Aug 24, 2010 10:09 pm
Location: CHI

RE: how to USB under qnx 6.4.1

Postby mario » Wed Nov 10, 2010 8:37 pm

What command are you talking about? What EXACTLY do you want to achieve.

I would assume the GPS uses serial over gps. I though QNX had a driver for that but couldn't find one, so look for yourself in case I missed it. Otherwise you have to write your own.

Just plug the device in if you see /dev/ser* (* being a number) appear then it means it's supported.
mario
QNX Master
 
Posts: 4132
Joined: Sun Sep 01, 2002 1:04 am

RE: how to USB under qnx 6.4.1

Postby lovelyp » Fri Jan 28, 2011 10:59 am

One more regarding USB in QNX.

Can we connect a pen drive to QNX and access the same from /dev ?? Is there any command to mount a USB drive?
lovelyp
Active Member
 
Posts: 23
Joined: Sat Jan 30, 2010 9:14 am

RE: how to USB under qnx 6.4.1

Postby mario » Fri Jan 28, 2011 1:57 pm

it should be autodetect and mounted under /fs/.
mario
QNX Master
 
Posts: 4132
Joined: Sun Sep 01, 2002 1:04 am


Return to Realtime and Embedded

Who is online

Users browsing this forum: No registered users and 3 guests