Skip navigation.
Home
The QNX Community Portal

View topic - Catch data through FLEET?

Page 1 of 1

Catch data through FLEET?

PostPosted: Mon Apr 30, 2012 5:03 pm
by rocking24
Tell me, please, is there such a tool (like wireshark, dsniff in window) that would catch the transported data (information) through a network of QNX4 FLEET?

Re: Catch data through FLEET?

PostPosted: Mon Apr 30, 2012 6:05 pm
by mario
Wireshark knows about fleet so you can use that. If you need to do it from QNX4, you first need to enable promiscious mode in the network driver (require a restart). Then you can use netsniff to capture and look at the data. This is VERY VERY basic, all texted based.

There use to be a very nice tool under Photon but it never got released unfortunately, politics.

Re: Catch data through FLEET?

PostPosted: Tue May 01, 2012 3:36 pm
by rocking24
mario wrote:Wireshark knows about fleet so you can use that.

Mario, thank you for reply! So, how to setup Wireshark to catch data only from fleet, not from tcp-ip(or other one)?

Re: Catch data through FLEET?

PostPosted: Tue May 01, 2012 4:43 pm
by mario
rocking24 wrote:
mario wrote:Wireshark knows about fleet so you can use that.

Mario, thank you for reply! So, how to setup Wireshark to catch data only from fleet, not from tcp-ip(or other one)?



Check Wireshark filters, just keep packet with ethertype of 0x8203