Skip navigation.
Home
The QNX Community Portal

View topic - High-speed CAN @ 1 Mbits not working in iMX6S based board..

Page 1 of 1

High-speed CAN @ 1 Mbits not working in iMX6S based board..

PostPosted: Wed Oct 08, 2014 9:43 am
by Zaheer
We are not able to transmit/receive any data from our iMX6S based custom board to a HS CAN simulator at a data-rate of 1 Mbits.

Started the driver with the following command “dev-can-mx35 -c 30000000 -B 0x01,0x03,0x07,0x01,0x01 -D -M -x can1”.
Tried to transfer data from the board to CAN simulator, but we do not see any data being received on the simulator.
The above setup works for a bit-rate of 125 Kbits.

The above bit-rate are based on the values for the following link i.e. http://www.port.de/en/bit-timing.html.
Options used are “Freescale flexi can” and “30 MHz CAN rate “.