Skip navigation.
Home
The QNX Community Portal

View topic - QNX and RS 232 connection with Windows XP

QNX and RS 232 connection with Windows XP

This is where you can ask a software to be ported or written for QNX. You can also request to buy/sell second hand software.

QNX and RS 232 connection with Windows XP

Postby b_bprimal » Sat Nov 22, 2008 7:03 pm

I have installed QNX as using VMWARE, I have Embedded board 6.2.1with QNX and I want to transfer file from VMWARE (where I have installed QNX) to another PC Windows XP.How can I do , Anyone can help me.I have try qtalk but could not get success.

Thanks
b_bprimal
New Member
 
Posts: 1
Joined: Sat Nov 22, 2008 6:57 pm

RE: QNX and RS 232 connection with Windows XP

Postby maschoen » Sun Nov 23, 2008 7:33 pm

Well using ftp or a similar network utility is an obvious route. If the file is small and you have a floppy, you could write to it in DOS format. If it is big and the network is too slow (hard to imagine these days) you could format a FAT32 partition and use that for transfer.
maschoen
QNX Master
 
Posts: 2644
Joined: Wed Jun 25, 2003 5:18 pm


Return to Request Software

Who is online

Users browsing this forum: No registered users and 1 guest