Skip navigation.
Home
The QNX Community Portal

View topic - ATMEL SAM7S256 USB to SERIAL DRIVER

ATMEL SAM7S256 USB to SERIAL DRIVER

This is where you can ask a software to be ported or written for QNX. You can also request to buy/sell second hand software.

ATMEL SAM7S256 USB to SERIAL DRIVER

Postby microhardsoft » Tue Feb 24, 2009 8:49 am

Im trying to get an ATMEL AT91SAM7S256 show up as a serial port when plugged into the USB of a PC running QNX6.4.

The device is running the CDC serial USB profile.
It shows up as a serial port under Windows (using the Windows builtin driver).

Under QNX enumerates as a USB device.
With #usb I can get the DID and VID.

I have tried to load devc-serusb with the DID and VID of the device but nothing happens.

The DID and VID is not supported in the QNX hardware list.

1. How could I load devc-serusb for a DID and VID which is not in the hardware list?

2. Once devc-serusb is loaded how will the serial port show up under /dev: as a serx serial port or as a ttysx port?

3. Anybody used SAM7S USB connected to QNX?

Thanks
microhardsoft
New Member
 
Posts: 2
Joined: Mon Feb 23, 2009 1:59 pm

Return to Request Software

Who is online

Users browsing this forum: No registered users and 2 guests