Skip navigation.
Home
The QNX Community Portal

View topic - USB to serial driver for FT232R in QNX 6.4.1

USB to serial driver for FT232R in QNX 6.4.1

This is where you can ask a software to be ported or written for QNX. You can also request to buy/sell second hand software.

USB to serial driver for FT232R in QNX 6.4.1

Postby Coolkillty » Mon May 17, 2010 11:06 am

Hi,

I am using an USB to serial converter IC in my project and its working fine in windows XP , i got the drivers from the FTDI page only, now i need drivers for QNX 6.4.1 can u please guide me where can i get them.

Thank you
Kitty
Coolkillty
New Member
 
Posts: 5
Joined: Mon May 17, 2010 11:03 am

RE: USB to serial driver for FT232R in QNX 6.4.1

Postby maschoen » Wed May 19, 2010 4:13 pm

Unless it is a standard driver, it seems unlikely to me that there would be support.
maschoen
QNX Master
 
Posts: 2640
Joined: Wed Jun 25, 2003 5:18 pm

RE: USB to serial driver for FT232R in QNX 6.4.1

Postby bone » Sat May 22, 2010 2:12 am

I've never tried to use these devices but it looks like some of the older chips are actually supported. See the following

http://www.qnx.com/developers/hardware_ ... l?chario=1
bone
New Member
 
Posts: 8
Joined: Wed Feb 14, 2007 1:39 pm

Postby Coolkillty » Wed May 26, 2010 10:12 am

Hi,

I am using a module which incorporates FT232RL IC from FTDI. The module is used to convert the serial data into USB and

pass it onto PC through the USB lines...

Now i need to work this project on my QNX 6.4.1 platform, the data transfer and all is working fine, but i need to know


how to access the port or GPIO or CBUS pins of the IC so that i can call some function and make the CBUS pins


controllable through software.

Can you please help me in this , it will be very needy ....
Coolkillty
New Member
 
Posts: 5
Joined: Mon May 17, 2010 11:03 am


Return to Request Software

Who is online

Users browsing this forum: No registered users and 2 guests