Skip navigation.
Home
The QNX Community Portal

View topic - Burning CDs - "OPC Failed"

Burning CDs - "OPC Failed"

This is where you can ask a software to be ported or written for QNX. You can also request to buy/sell second hand software.

Burning CDs - "OPC Failed"

Postby sheran.vaz » Wed Feb 11, 2015 7:59 pm

Hi,

I have been using cdrecord for burning CDs in QNX,

After i changed to different drive, i'm getting "OPC Failed"

Any ideas on how to correct this?

Regards
Sheran
sheran.vaz
Active Member
 
Posts: 98
Joined: Mon May 11, 2009 9:17 am

Re: Burning CDs - "OPC Failed"

Postby maschoen » Thu Feb 12, 2015 5:23 pm

By any chance, did you switch from a writable CD drive to a writable DVD drive?

A while ago I had a customer who was testing with a CD drive and it worked fine, but when they upgraded to a DVD it stopped working. I don't remember the error they were receiving. At one point they purchased a license for the non-free version, and I believe they found it had the same problem. Their solution was to find hardware that worked rather than fixing the software.
maschoen
QNX Master
 
Posts: 2640
Joined: Wed Jun 25, 2003 5:18 pm

Re: Burning CDs - "OPC Failed"

Postby sheran.vaz » Thu Feb 12, 2015 9:55 pm

My previous and current drives are both DVD drives.

The Medium i'm using is only CD.
sheran.vaz
Active Member
 
Posts: 98
Joined: Mon May 11, 2009 9:17 am

Re: Burning CDs - "OPC Failed"

Postby maschoen » Thu Feb 12, 2015 10:14 pm

sheran.vaz wrote:My previous and current drives are both DVD drives.

The Medium i'm using is only CD.


Well it sounds like an unsupported drive.
maschoen
QNX Master
 
Posts: 2640
Joined: Wed Jun 25, 2003 5:18 pm

Re: Burning CDs - "OPC Failed"

Postby sheran.vaz » Fri Feb 13, 2015 9:22 pm

Any ideas on how to fix it?
sheran.vaz
Active Member
 
Posts: 98
Joined: Mon May 11, 2009 9:17 am

Re: Burning CDs - "OPC Failed"

Postby sheran.vaz » Fri Feb 13, 2015 9:50 pm

Immediately after burning a multisession CD, i'm not able to read the contents fo the CD, i can c only the old contents. To view the new contents i have to eject and then re-insert.

Y is this?
sheran.vaz
Active Member
 
Posts: 98
Joined: Mon May 11, 2009 9:17 am

Re: Burning CDs - "OPC Failed"

Postby maschoen » Sat Feb 14, 2015 12:19 am

The most direct solution would be to find some other supply of hardware that is supported.
If that is not an option you have to directions to go in.

1) Contact the author and see what he would charge to provide support.

2) Hire a qualified driver person (I humbly include myself) and have them add support.
maschoen
QNX Master
 
Posts: 2640
Joined: Wed Jun 25, 2003 5:18 pm


Return to Request Software

Who is online

Users browsing this forum: No registered users and 1 guest

cron