Skip navigation.
Home
The QNX Community Portal

View topic - Configuring QNX 6.3.2 for a radeon driver.

Configuring QNX 6.3.2 for a radeon driver.

Read-only archive of qnx.newuser (Installation, configuration and administration of the QNX Neutrino or QNX Momentics environments) at inn.qnx.com

Configuring QNX 6.3.2 for a radeon driver.

Postby scobb » Sat Sep 29, 2007 3:50 am

I just installed the latest 6.3.2 NC onto an x86 system.

It installed fine and I'm currently using the vesa graphics driver.
I would like to set it up to use a more appropriate readeon driver.

According to the pci command:
Class = Display (VGA)
Vendor ID = 1002h, ATI Technologies Inc
Device ID = 5974h, RS482 [Radeon Xpress 200]
PCI index = 0h
PCI Mem Address = d8000000h enabled
PCI IO Address = ee00h disabled
PCI Mem Address = fdef0000h enabled
PCI Expansion ROM = 0h disabled
PCI Int Pin = INT A
Interrupt line = 11
CPU Interrupt = bh


How do I configure it to use the devg-radeon.so driver?

Oh, and crttrap yields:

io-graphics -dvesabios vid=0x1002,did=0x5974,index=0,photon,xres=1600,yres=1200,bitpp=16 -pphoton ;#1600,1200,16,100,0D,vesa - unaccelerated driver for VESA 2.00 compliant adapters

Thanks,
Steve
scobb
New Member
 
Posts: 7
Joined: Wed Jun 18, 2003 2:47 am

Re: Configuring QNX 6.3.2 for a radeon driver.

Postby Yuriy Synytskyy » Mon Oct 01, 2007 2:41 pm

Hello Steve,

As a first step it is worth checking whether Device ID = 5974h

is mentioned in QNX supported hardware database

http://www.qnx.com/developers/hardware_support/



Yuriy



"scobb" <scobb@think-ware-dot-com.no-spam.invalid> wrote in message
news:fdki65$no7$1@inn.qnx.com...
I just installed the latest 6.3.2 NC onto an x86 system.

It installed fine and I'm currently using the vesa graphics driver.
I would like to set it up to use a more appropriate readeon driver.

According to the pci command:
Class = Display (VGA)
Vendor ID = 1002h, ATI Technologies Inc
Device ID = 5974h, RS482 [Radeon Xpress 200]
PCI index = 0h
PCI Mem Address = d8000000h enabled
PCI IO Address = ee00h disabled
PCI Mem Address = fdef0000h enabled
PCI Expansion ROM = 0h disabled
PCI Int Pin = INT A
Interrupt line = 11
CPU Interrupt = bh


How do I configure it to use the devg-radeon.so driver?

Oh, and crttrap yields:

io-graphics -dvesabios
vid=0x1002,did=0x5974,index=0,photon,xres=1600,yres=1200,bitpp=16
-pphoton ;#1600,1200,16,100,0D,vesa - unaccelerated driver for VESA
2.00 compliant adapters

Thanks,
Steve
Yuriy Synytskyy
 


Return to qnx.newuser

Who is online

Users browsing this forum: No registered users and 2 guests