Skip navigation.
Home
The QNX Community Portal

View topic - Broacom BCM4401-B0

Broacom BCM4401-B0

Read-only archive of qnx.rtos (Writing resources managers, and general discussion around the QNX Neutrino RTOS) at inn.qnx.com

Re: Broacom BCM4401-B0

Postby seanb » Fri Dec 07, 2007 2:17 pm

Augie <augiehenriques@hotmail.com> wrote:
Something wrong with that link?

It works for me...

There's also a link to it under the "How do I port a NetBSD
driver" section on this page of the networking wiki:
http://community.qnx.com/sf/wiki/do/vie ... _wiki_page

-seanb
seanb
QNX Master
 
Posts: 133
Joined: Fri Jul 28, 2006 5:36 pm

Re: Broacom BCM4401-B0

Postby Augie » Fri Dec 07, 2007 2:43 pm

Sean,

Thanks... That second link worked...

I know there are Linux drivers for this card.

There was also an article at www.openqnx.com from "phearbear " about a port
of Linux drivers for the Broadcom 440X network card...

Any chance someone has done this? is working on this?

What is the best way to go here?

Any way I or someone else can do this and be contributed back to all?

TIA

Augie

"Sean Boudreau" <seanb@qnx.com> wrote in message
news:fjbkl1$18q$1@inn.qnx.com...
Augie <augiehenriques@hotmail.com> wrote:
Something wrong with that link?

It works for me...

There's also a link to it under the "How do I port a NetBSD
driver" section on this page of the networking wiki:
http://community.qnx.com/sf/wiki/do/vie ... _wiki_page

-seanb
Augie
 

Re: Broacom BCM4401-B0

Postby seanb » Fri Dec 07, 2007 7:44 pm

Augie <augiehenriques@hotmail.com> wrote:
Sean,

Thanks... That second link worked...

I know there are Linux drivers for this card.

There was also an article at www.openqnx.com from "phearbear " about a port
of Linux drivers for the Broadcom 440X network card...

Any chance someone has done this? is working on this?

What is the best way to go here?

Any way I or someone else can do this and be contributed back to all?

If you get something working we can create a sys/dev_contrib
section or some such under the networking project. I'd
start with the NetBSD code though; probably under their
netbsd-4 branch. We won't take back linux code.

-seanb
seanb
QNX Master
 
Posts: 133
Joined: Fri Jul 28, 2006 5:36 pm

Previous

Return to qnx.rtos

Who is online

Users browsing this forum: No registered users and 2 guests