Skip navigation.
Home
The QNX Community Portal

View topic - How to install CAN Driver with Athena Board

How to install CAN Driver with Athena Board

Read-only archive of qnx.bsp (Discuss building an image, flashing a board or using a BSP) at inn.qnx.com

How to install CAN Driver with Athena Board

Postby Lily » Thu Jun 14, 2007 4:54 pm

Hello,

I am buiding an embdded system with Athena board and QNX. I have an
Athena400 board, 128M RAM, with QNX installed on a flask disk from the
factory. I want to install CAN driver and start it when QNX boots. But NO
qinstall in the embedded image. Does any one know how to do it without
modifying the image and no qinstall? I have the CAN driver named
devn-can1000.

Thanks for any help or hints.

Fan
Lily
 

Re: How to install CAN Driver with Athena Board

Postby fanxm0712 » Wed Jun 20, 2007 6:16 pm

No one know?

Lily wrote:
Hello,

I am buiding an embdded system with Athena board and QNX. I have an
Athena400 board, 128M RAM, with QNX installed on a flask disk from the
factory. I want to install CAN driver and start it when QNX boots. But NO
qinstall in the embedded image. Does any one know how to do it without
modifying the image and no qinstall? I have the CAN driver named
devn-can1000.

Thanks for any help or hints.

Fan

fanxm0712
New Member
 
Posts: 2
Joined: Wed Jun 06, 2007 4:39 pm


Return to qnx.bsp

Who is online

Users browsing this forum: No registered users and 1 guest