Skip navigation.
Home
The QNX Community Portal

View topic - ual port memory problem

ual port memory problem

Read-only archive of qnx.qnx4 (General QNX4 Discussion Group) at inn.qnx.com

ual port memory problem

Postby Guest » Tue Jun 26, 2007 5:48 am

I am working with a piece of hardware that requires me to map to two regions of dual-port
[shared] memory. The PCI provides me with two addresses and lengths that I subsequently use with
mmap() to obtain two pointer references.

Region0 is 4096 bytes long and region1 is 16384 bytes long. The problem I am having is in
regards to region1 - region0 is fine.

This device has two ASIC's: the first is at the address of region1 (say 0x00018000) and the
second ASIC is 4096 bytes above that (0x00019000). The problem is that even though the length
argument to mmap is 16384, a valid address is returned, and errno is EOK, all memory beyond
region1 + 4096 (0x1000) (being the 2nd ASIC) is -1 (0xff). I note that this equates to the 2nd
page of memory and am not sure if this is coincidental or not. The first ASIC is fine.

I know that the card is working properly as a Linux based test utility works fine (in teh same
machine) with both ASICS. The problem I have occurs with both QNX4 and QNX6. While I have tried
to replicate the Linux code, it uses ioremap() so I can't do an exact translation.

The QNX4 mmap() routine is as follows:

char *allocBuf(int addr, unsigned long nbytes)
{
int fd;
char *ptr;

if ((fd = shm_open("Physical", O_RDWR, 0777)) == -1)
return((char *) -1);

ptr = (char *) mmap(0, nbytes, PROT_READ | PROT_WRITE | PROT_NOCACHE, MAP_SHARED, fd, addr);

close(fd);

return (ptr);
}

Is there something I'm missing with the way I am using mmap()? Are there any issues regarding
access to dual port memory areas greater than one page in both QNX4 and QNX6?

Thanks,

Geoff Roberts
Guest
 

Return to qnx.qnx4

Who is online

Users browsing this forum: No registered users and 1 guest