Skip navigation.
Home
The QNX Community Portal

View topic - QNX6 installation could not find Compact Flash

QNX6 installation could not find Compact Flash

Read-only archive of qnx.evaluation (Evaluation) at inn.qnx.com

QNX6 installation could not find Compact Flash

Postby RPan » Mon May 01, 2006 3:36 pm

Our system is PC/104+ based. It has one compact flash and one IDE.
I boot the QNX Neutrino from CD and Select F3 (Install QNX to a new disk
partition).

After I enter the license key, the installation could not find any disk in
the system. I have no disk to select for OS installation. How come? CF is
there and If I run from CD(F2 selection), /dev/hd0 shows up.

Any ideas?

RF
RPan
 

Re: QNX6 installation could not find Compact Flash

Postby Maciek » Sat May 20, 2006 4:00 pm

Our system is PC/104+ based. It has one compact flash and one IDE.
I boot the QNX Neutrino from CD and Select F3 (Install QNX to a new disk
partition).

After I enter the license key, the installation could not find any disk in
the system. I have no disk to select for OS installation. How come? CF is
there and If I run from CD(F2 selection), /dev/hd0 shows up.

Any ideas?

Hi,
I had the same problem. Fortunatelly I found a solution. You have to disable
DMA. There is a messsage "press spacebar to ........ or press D to disable
DMA" (or something like that) before entering the license key. Just press D.
In my case it helped and my CF card was in the list.
Regards,
Maciej
Maciek
 

RE: Re: QNX6 installation could not find Compact Flash

Postby mpwalter » Mon May 29, 2006 6:07 am

did the bios found the cf-card (...correctyl?) - check this first! somethimes you must use manually settings in the bios
mpwalter
Active Member
 
Posts: 56
Joined: Tue Feb 07, 2006 9:20 am


Return to qnx.evaluation

Who is online

Users browsing this forum: No registered users and 1 guest