Skip navigation.
Home
The QNX Community Portal

View topic - Comms problem

Comms problem

Discussions, suggestions, requests about this website.

Comms problem

Postby coomber » Thu Jun 16, 2011 7:21 am

Hi again guys, I have another problem.The machine I am working on runs QNX4 but for some reason the floppy drive will not work. when you try to access the disc in either dos mode or qnx mode the drive light comes on and stays on locking up the machine even though a QNX boot disc works perfectly.
Also the dnc communications will not talk to an external computer even though when you short out transmit and receive on the machine end you get test ok. All the baud rate etc are set correctly and two computers have been tried. All you get is test received but no reply and then time out. Could this be some kind of security issue ? Regards Dave
coomber
New Member
 
Posts: 5
Joined: Mon Jun 13, 2011 6:09 pm

Return to OpenQNX Site

Who is online

Users browsing this forum: No registered users and 1 guest