Skip navigation.
Home
The QNX Community Portal

View topic - booting problem at qnx based cnc machine os

booting problem at qnx based cnc machine os

General Help about QNX

booting problem at qnx based cnc machine os

Postby mem86 » Thu Aug 09, 2012 8:12 pm

hi all,

i m a junior engineer at pcb manucfactoring compony's cnc departmant and i have started to work in this monday :mrgreen: so we have cnc mahchine posalux 6000 which has qnx based os cnc 3000 ver 1.5

problem is : after turning on the maching during the operating systems's booting process we are getting this error message:


fat(0x9100) time out :20 sec subcode1=1 subcode2=0

its looks like a bad sector at hdd to me

any ideas??

Best Regards,

Mehmet
mem86
New Member
 
Posts: 1
Joined: Thu Aug 09, 2012 8:03 pm

Re: booting problem at qnx based cnc machine os

Postby maschoen » Fri Aug 10, 2012 8:15 pm

[quote="mem86"]hi all,

i m a junior engineer at pcb manucfactoring compony's cnc departmant and i have started to work in this monday :mrgreen: so we have cnc mahchine posalux 6000 which has qnx based os cnc 3000 ver 1.5

VER 1.5 probably refers to the CNC manufacturer's version. QNX version 1.5 is ancient, almost beyond belief, probably close to 28years old.



problem is : after turning on the maching during the operating systems's booting process we are getting this error message:


fat(0x9100) time out :20 sec subcode1=1 subcode2=0

I have lots of experience with QNX systems, 2, 4 and 6. I've never seen a message like this. It could be something from the BIOS. What's most suspicious is the letters FAT. This is highly suggestive of the DOS FAT file system. It is possible for a QNX system to read a FAT file system, but it is doubtful this would happen on startup.

Do you see any text before this message?


> its looks like a bad sector at hdd to me

A reasonably good guess. If it is, do you have installation disks for the software?
maschoen
QNX Master
 
Posts: 2644
Joined: Wed Jun 25, 2003 5:18 pm


Return to Help

Who is online

Users browsing this forum: No registered users and 1 guest