Skip navigation.
Home
The QNX Community Portal

View topic - QNX 4.25 installation in latest dual core system

QNX 4.25 installation in latest dual core system

For the old QNX2 and QNX4 RTOS

QNX 4.25 installation in latest dual core system

Postby girishgnayak » Sat Apr 30, 2011 7:41 am

Hai iam trying to install qnx4.25 in latest dual core pc while booting frm...Cd after some second display will gone blank...but iam successfully installed through virtual machine in same system....pls suggest me how to install directly in system,,,,,,,,


Girish G Nayak
girishgnayak
New Member
 
Posts: 1
Joined: Sat Apr 30, 2011 7:36 am

RE: QNX 4.25 installation in latest dual core system

Postby maschoen » Sat Apr 30, 2011 2:23 pm

I'm going to attempt a translation for others:

====================================================
Hi, I am trying to install QNX 4.25 in the latest dual core pc by booting from a CD.
After a few seconds, the display goes blank.
I can install on a virtual machine on the same system.
Please tell me how to install directly.
====================================================

First of all, QNX 4.25 does not support Dual core so at best you will be able to
run on just one processor.

The problem you are having sounds like a graphics driver problem.
This is not a big surprise.
Unfortunately the CD version of QNX 4.25 depends on getting the GUI Photon
running before installation.

You could try putting in an older graphics card.
Otherwise using the older floppy installation might work better.
maschoen
QNX Master
 
Posts: 2640
Joined: Wed Jun 25, 2003 5:18 pm


Return to QNX2 and QNX4

Who is online

Users browsing this forum: No registered users and 2 guests