Skip navigation.
Home
The QNX Community Portal

View topic - reformatting a qnx4 hd

reformatting a qnx4 hd

For the old QNX2 and QNX4 RTOS

reformatting a qnx4 hd

Postby dazza40 » Wed May 25, 2011 10:34 am

This question probably has an easy answer but i cannot find it for the life of me.

I have a couple of hard drives that are formatted to qnx4.25 and would like to use them on windows based machines.

There is no dos partitions on them.

How do I do this ?

Dazza
dazza40
New Member
 
Posts: 1
Joined: Wed May 25, 2011 10:27 am

Postby Tim » Wed May 25, 2011 1:54 pm

Use 'fdisk' and change the partition type to DOS.

Then you can re-format the drives in Windows.

Tim
Tim
Senior Member
 
Posts: 1388
Joined: Wed Mar 10, 2004 12:28 am

Postby ingraham » Wed May 25, 2011 10:12 pm

I am puzzled by this question. Under what circumstances do you have QNX4 hard drives that you can essentially throw away, but are so hard up for storage that you want to re-use them? I doubt these are particularly large drives; QNX4 was dying out around 2002-2003, and most QNX systems didn't need a lot of space, so I'm guessing these drives are no larger than 80GB, if that. They are also probably quite old, which means possibly closer to failure.

Storage is ludicrously cheap these days. I have a half-dozen drives sitting on a shelf at home collecting dust. I just bought some 4GB SD cards and USB sticks for less than 10 bucks. A new 160GB hard drive from Newegg is $35, ($42 shipping).

While fdisk is the technical answer to your question, a more prudent route is probably to buy (or get someone to give you) a drive in a known-good condition.

-James Ingraham
Sage Automation, Inc.
ingraham
Senior Member
 
Posts: 160
Joined: Wed Nov 05, 2003 2:25 pm
Location: Texas


Return to QNX2 and QNX4

Who is online

Users browsing this forum: No registered users and 4 guests