Skip navigation.
Home
The QNX Community Portal

View topic - QNX 4.25 - how to start on normally system

QNX 4.25 - how to start on normally system

For the old QNX2 and QNX4 RTOS

QNX 4.25 - how to start on normally system

Postby shirokolobov » Fri Dec 09, 2011 8:24 am

Since 1995, operate a system of Intel 386DX-33/RAM 8Mb/HDD 300Mb QNX 2.2 release 8, RealFLEX 1.22. About 2 years ago, the system has become hang when viewing reports (trends).
How can I upgrade to a system and really start the QNX 4.25.
I think it is necessary to increase the amount of memory and hard disk.
At Intel D865GLC, D915GAG, 440BX QNX boots
with the output lines at startup
. / altboot..............................D
and further zagrueka happens.
Here, in our reading that QNX 4.25 supports up to ICH5,
At 486DX100 not loaded.
question:
The problem stems from the hard drive? with the video card? from the hard disk controller?

Thanks.
Dmitry
Russia
shirokolobov
New Member
 
Posts: 2
Joined: Fri Dec 09, 2011 7:44 am

Re: QNX 4.25 - how to start on normally system

Postby maschoen » Sun Dec 11, 2011 2:42 am

The 'D' is an I/O error of some kind. You probably need a new hard drive. You can use a CF card with an adapter if the current drive is IDE.
maschoen
QNX Master
 
Posts: 2640
Joined: Wed Jun 25, 2003 5:18 pm


Return to QNX2 and QNX4

Who is online

Users browsing this forum: No registered users and 1 guest