Finally, I found some sample codes and I could compile it successfully, but
when I tried to Run it or Debug it, I got an error msg saying "Launch
Failed: Error starting process: Exec error: Launching failed" (BTW, I'm
using the QNX Momentics.)
Any suggestions?
Roger
Debugging 101
Re: Debugging 101
roger <rogeryung@mtmeng.com> wrote:
click on the "Upload" tab, and try un-setting the "Strip debug...."
option. On your target, make sure you have a "/tmp" directory.
If you don't, either create one, or modify the "Upload directory"
to point to some directory that actually exists.
-David
--
QNX Training Services
http://www.qnx.com/support/training/
Please followup in this newsgroup if you have further questions.
Assuming 6.2.1B, Windows hosted. In your launch configuration,Finally, I found some sample codes and I could compile it successfully, but
when I tried to Run it or Debug it, I got an error msg saying "Launch
Failed: Error starting process: Exec error: Launching failed" (BTW, I'm
using the QNX Momentics.)
Any suggestions?
click on the "Upload" tab, and try un-setting the "Strip debug...."
option. On your target, make sure you have a "/tmp" directory.
If you don't, either create one, or modify the "Upload directory"
to point to some directory that actually exists.
-David
--
QNX Training Services
http://www.qnx.com/support/training/
Please followup in this newsgroup if you have further questions.