An error of starting up empress database

bridged with qdn.public.qnxrtp.newuser
Post Reply
wyh

An error of starting up empress database

Post by wyh » Wed Sep 10, 2003 8:28 am

Hello everyone
I am a new user of QNX 6.X. I have a problem. I install a database
Empress 8.60 on QNX 6.X, but when I check "enable device" of NetWork,
empress can not be run well ,only when I uncheck "enable device" of NetWork,
the empress is ok. Could you help me?

Regards.

wyh

commissor

Re: An error of starting up empress database

Post by commissor » Thu Sep 18, 2003 9:09 am

wyh wrote:
Hello everyone
I am a new user of QNX 6.X. I have a problem. I install a database
Empress 8.60 on QNX 6.X, but when I check "enable device" of NetWork,
empress can not be run well ,only when I uncheck "enable device" of NetWork,
the empress is ok. Could you help me?

Regards.

wyh


I'm a new user of Empress,too.
Do you mean the problem during installation?
I think you can config your IP address with 192.168.1.1.

Post Reply

Return to “qdn.public.qnxrtp.newuser”