First Boot after installation on CF got error?

bridged with qnx.newuser
Post Reply
andrew1980

First Boot after installation on CF got error?

Post by andrew1980 » Thu Sep 28, 2006 3:50 am

Hi all

After the installation(on a PC104 board, with a CF) , during the first
boot up I got the following message.

Error Msg:

"No valid commercial license found"
"Only non-commercial use of this software is permitted".
"Contact QNX Software Systems to acquire a development
license"

"Spawn of /bin/sh failed - no such file or directory".

Then, nothing. No prompt. and nothing happen

I have a licensed copy so any advice on this?

Thanks

regards

techeval

Spawn of /bin/sh failed

Post by techeval » Fri Dec 08, 2006 5:53 pm

Hi,

I have the exact same problem. Could somebody please help me resolve
this ? Thanks a bunch.

Regards,
N

maldini1010

Same Problem

Post by maldini1010 » Fri Jan 12, 2007 9:50 pm

It seems I have the same problem.. I get the exact message. after
installing QNX 6.3. However I am installing it on a flash disk,, and
performing the same procedures on an older 512 MB kingston flash and
on a new 512 MB kington flash does not give the same result.

That is on the older one it works, on the new one I get this message.
I called kingston, they told me that they no longer support their
flash to behave as IDE...This is probably my problem, and I would
like to know if any other are having this problem

maldini

maldini1010

RE: Same Problem

Post by maldini1010 » Thu Jan 18, 2007 5:49 pm

See Forum, for more details.

PC104 using CF, takes forever to install qnx, how come?

Post Reply

Return to “qnx.newuser”